The Pedal Power Generator Products description

•  Generator mounting bracket

  The generator mount attaches the generator to the bike with a rub roller on the end of the generator that rub, in proper alignment, against the tire. It has a cable with a thumb shifter that is located for easy reach, usually on the handlebars. The thumb shifter is used to engage and disengage the generator. It is also use to apply the proper tension of the rub roller to the tire, for maximum efficiency and minimum wear. Includes generator with wiring harness that attaches to th regulator. The generator is mounted in a water resistant cabinet.

•  Regulator cabinet

  Includes diode, connectors, fuses, and 58F Capacitor. Has connection at both ends for generator, power out, battery. Indicator, and 12v accessories (DLG, Lights...) It is a water resistant housing with ventilation at both ends. It has the capability of housing Upgrades.

•  Indicator

  Can be clipped to the handle bar for easy viewing. Lets the peddler know how much power is being applied to the system. Is necessary for preventing the capacitor from being over charged and the protection of 12v equipment attached to the out put. Includes cable and instructions.

•  Center Stand

  The center stand that keeps the rear tire off the ground for pedaling in place. It operates like a motorcycle kickstand in that a spring pivots it out of the way and can kicked in to place with your foot.

• Complete Unit (1,2,3,&4)

  Includes generator with mount, regulator cabinet with capacitor, center stand, indicator, manual, and installation instructions. The system is easy to install and operate, weighing only 10 lbs.